The belt is supposed to be tightened to the plate by a part not shown on the joined photo). I am expecting to link the plate to the belt, the belt fitting a groove machined in the plate (showing in yellow on the joined photo). Now I am actually expecting the belt to drive the sliding plate. This assembly is composed of 2 pulleys, a belt (showing in red on the joined photo) and a sliding plate.Ĭurrently I can create the belt/chain system between the 2 pulleys (excluding the sliding plate): this works fine and when I rotate one pulley by hand, I can see the other one rotating accordingly. I am currently putting in place a linear guide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |